Aritech ATS4000 Manual de Serviço descarregar pdf (Página 20)

20 ATS Designers Guide

programmed to act as alarm zones of the alarm system. The readers and access control

keyboards of the ATS1250 DGP can be used to the alarm system control functions.

Configuration details using the ATS1250 device can be found in section 4.4.2.

Table 1-19 DGP ATS1250 compatible expansion modules

Expansion Description Amt. Size

Memory – mounted in the slot on the mainboard, only one of the following modules.

ATS1830 1Mb – pre-installed -

ATS1831 4Mb, IUM -

ATS1832 8Mb, IUM

Outputs– mounted in available housing slots

ATS1810 4 relay outputs 2 B

ATS1811 8 relay outputs 6 BB

ATS1820 16 open collector outputs 3 B+

Table 1-20 DGP ATS1250.housing space

L – ATS1642 housing

Battery Capacity Free housing slots

BS127N 7.2Ah

2xBS127N 14.4Ah

BS131N 18Ah

BS129N 26Ah

2xBS129N 52Ah

6xB or 3xBB or 4xB+

1.3.1.7

ATS1260 4 lift Access Control DGP.

4 elevators (lifts)

64 elevator floors

4 direct Wiegand reader inputs

16 remote readers on the local bus

15 local DGP (256 zones – one for every floor in each

elevator)

16 dedicated onboard inputs

4 relay outputs (expandable to 256)

Advanced access control functions

48 macrodefinitions

Full local copy of the user database

Autonomous operation mode

Integrated 4.5A switched mode power supply

Auxiliary battery back-up

L type housing

Dimensions: D

The lift controller was based on the ATS1250 4-door controller hardware. The device is

supplied as a set ATS1250+ATS1260UP – a lift controller software and instruction

manual package and the ATS1250. Because of that, the available space details in the

ATS1260 housing, are identical with those of ATS1250, detailed in Table 1-20.

Contrary to the ATS1250 the elevator control DGP requires installation of additional local

DGP modules in order o achieve the maximum amount of 256 floor request inputs

(4 elevators x 64 floors), and 256 outputs for visualization of the selected floors. The

ATS1260 DGP is compatible with every alarm zone DGP of the ATS system, and every

RAS station of the ATS system, see Table 1-10), using the ATS1170 and the IUM

function with every Wiegand interface reader, and 48-bit cards. The local bus design

procedure has been outlined in section 3.2.1.

Table 1-21 ATS1260 DGP compatible expansion modules.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 82 83

Comentários a estes Manuais

Sem comentários

Aritech ATS4000 Manual de Serviço Página 20

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Aritech ATS4000