Aritech CS175 Guia de Instalação descarregar pdf (Página 32)

CS175-275-575-875 Installation Guide

6 WIRING ZONES

6.1 General

The control unit inputs are set up as standard EOL (4K7) freely programmable zones.

However, by programming the zones as dual loop, all control unit zone inputs can be

programmed to provide alarm and tamper indications on the same zone.

6.2 Dual wiring

One zone includes both alarm and tamper wiring.

The alarm devices are wired in series and a 4K7 resistor is fitted in parallel across the

closed circuit contacts.

The tamper contacts are wired in series with a 4K7 EOL resistor.

•

All devices closed - loop resistance is 4K7.

•

Tamper device open - loop is an open or short circuit.

•

Alarm device open - loop resistance is 9K4 (EOL resistor PLUS parallel resistor).

4K7

E.O.L.

Zone terminal

Alarm contact

Sensor

Tamper contact

6.3 Single wiring

Two zones are required, one zone for alarm and one zone for tamper. The tamper

contacts are wired in series with a 4K7 EOL resistor.

4K7

E.O.L.

4K7

E.O.L.

Zone terminal

Alarm contact

Sensor

Tamper contact

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 166 167

Sem comentários

Aritech CS175 Guia de Instalação Página 32