Aritech ADVISOR CD 7203 Manual do Utilizador descarregar pdf (Página 104)

Page 104 Manager Manual for the CD72/95/15001

Message Description

Alarm is reset

The system cannot be disarmed except between the start and stop time of the

timeslot. The system can only be reset in the event of an alarm.

Area n Arming

The warning time for area n has started. The system must be armed before the

warning time expires.

Area n Timeslot

Area n cannot be disarmed except between the start and stop time of the

timeslot. This message appears when the code is entered.

Auto ArmArean

The warning time for area n has started. After the warning time the system will

arm automatically.

Call engineer

An engineer reset is necessary. The client cannot arm until this has been done

Change code NOW!

The code will be deleted in 5 days unless the code is changed before then.

Dialler EEPROM

A fault has been found in the programming data in the dialler

Disarm Not Poss.

It is not possible to disarm with this code

EEPROM xxx

There is a fault in the programming data in the panel. xxx is a number indicating

which parts of the programming have a problem. This number may consist of

the following options (by adding up):

xxx fault

1 In zones and outputs (not the names)

2 In programming of separate systems

4 In programming of system options

8 In user codes, engineer code and U/D codes (not the names)

128 During EEPROM read or write operation

Fault

The new code entered already exists or has not been authorised

nnnTZone name

During display of open zones. The zone has had a tamper. A double loop

connection has been used.

Nd-No Panel Data

The control panel is receiving no more data from the panel

No Access

This code grants no access or the code has been entered too slowly

No Ack detect.

During manual test report. The dialler sees no acknowledgement of the report.

Possibly wrong protocol

No Arm:Walk Test!

The system cannot be armed before a complete walk test has taken place.

No dialling tone

During manual test report. The dialler detects no dialling tone

No handshake

During manual test report. The dialler does not receive a handshake. Possibly

wrong telephone number or wrong report bank/protocol

No Preference

No extended access is requested or a system is still in triggered state (only in a

split system)

Not authorised

The required bridging has not been authorised

Remote Supply An ‘Auxiliary Power’ input has been disrupted

RKP blocked The control panel has been blocked via an ‘RKP unusable’ zone

RKP fault

One or more control panels/expanders are no longer reacting

Syst Busy

An operation is still busy on another control panel

Timeslot Disarm

A user code is blocked by the timer.

U/D busy

An up/download connection has been made

Verify

Enter your code again (to verify a new or changed code)

Walk Test Required!

A walk test must be carried out.

Table two. Other messages in the display

Technical Manuals Online! - http://www.tech-man.com

1 2 ... 99 100 101 102 103 104 105 106 107 108

Comentários a estes Manuais

Sem comentários

Aritech ADVISOR CD 7203 Manual do Utilizador Página 104

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Aritech ADVISOR CD 7203